澳门太阳集团20056com:山东铜门贴膜需要注意的事项 - 济南别墅铜门

澳门太阳集团20056com

网站关键词: 山东铜门提醒你铜门刷漆需要注意的问题 工程铜门1 工程铜门 沈阳老菜馆 济南机场路
当前所在位置:首页>>新闻中心>>山东铜门贴膜需要注意的事项新闻中心

山东铜门贴膜需要注意的事项

来源: 日期:2020-07-17 发布人:qinfu浏览次数:
铜门的使用寿命再长,再稳定也是需要我们用心呵护的。铜门贴膜就像我们为自己的手机贴膜可保护铜门的表面。但同样铜门玻璃贴膜需要注意一些事项,
No matter how long the service life of the copper door is, no matter how stable it is, we need to take good care of it. The copper door film can protect the surface of the copper door just like we do for our mobile phone. However, there are also some matters needing attention when pasting the glass film on the copper door,
1、在玻璃铜门贴膜安装后的三内,不要移动玻璃,因为里面可能含有水(水还没有蒸发掉),所以好不要移动。
1. Do not move the glass within three days after the installation of glass copper door film, because it may contain water (water has not evaporated), so do not move.
山东铜门
Tongmen, Shandong
2、在玻璃贴好摸的十五天以内,不要用水来清洗贴膜的铜门玻璃。
2. Do not use water to clean the coated copper door glass within 15 days after the glass is pasted.
3、在贴膜的铜门玻璃上面不要用可以悬挂黏胶固定的物品,也不能在窗膜上面粘贴不干胶等装饰品。
3. Don't use things that can be fixed by hanging glue on the coated copper door glass, or stick self-adhesive and other decorations on the window film.
4、清洗剂轻微均匀地喷洒窗膜表面,然后用清洁、柔软的棉布或吸水擦拭布轻轻地擦干窗膜,棉布和吸水擦拭布常常需要拧干,含在棉布/吸水擦拭布上的外用酒精将很快溶解的污渍和多脂的指纹。如果污渍?有洗净,重新喷洒清洗液,用软X橡胶刮水擦从上到下水平地刮擦窗膜直至擦干,用毛巾擦干窗膜的边缘。
4. The surface of the window film is slightly and evenly sprayed with the cleaning agent, and then the window film is gently dried with a clean, soft cotton cloth or water absorbing wiping cloth. The cotton cloth and water absorbing wiping cloth often need to be wrung out. The external alcohol contained in the cotton cloth / absorbent wiping cloth will quickly dissolve the stains and fatty fingerprints. If the stain is cleaned, spray the cleaning solution again, scrape the window film horizontally from top to bottom with soft X rubber wiper until it is dry, and wipe the edge of the window film with towel.
山东铜门
 
5、铜门玻璃膜上因使用胶粘带、即使贴或者贴花纸,清楚这些材料的时候残留下的胶水或者黏胶,可以用软X洁净棉布蘸上丙酮轻轻地擦洗受污染的区域,就能很快地清楚这些残留在窗膜上的黏胶。少量的丙酮不会损聚酯薄膜,却能溶解和蒸发黏胶及大多数喷漆。
5. For the use of adhesive tape, even paste or decal paper on the glass film of copper door, the residual glue or glue left when these materials are removed can be cleaned by gently scrubbing the contaminated area with soft X clean cotton cloth dipped in acetone, and the residual glue on the window film can be quickly removed. A small amount of acetone does not damage the polyester film, but dissolves and evaporates the adhesive and most spray paint.
6、不能使用软X的擦板、刷子、含有沙粒的工具进行清洁,这样很容易划铜门的表面。
6. Do not use soft X wiping board, brush, tools containing sand particles for cleaning, which is easy to scratch the surface of the copper door.
新闻资讯
-News and information-
?
在线客服
  • 点击这里给我发消息
二维码

澳门太阳集团20056com:扫描二维码

澳门太阳集团20056com-太阳集团娱乐网址55080